One is flexible plastic, the other rigid metal. Pex tubing bends around corners, uses crimp or clamp rings at its joints, and tolerates a cold snap. Copper is hard-drawn metal, soldered or pressed at the joints, with decades of history behind it. Both belong in a house here, and the winner depends on how reachable the walls are, how much you can spend and the water your utility delivers. The page sits under our repiping and pipe replacement service and lays out the differences without hype.
What actually sets the two materials apart?
Pex is cross-linked polyethylene, sold in coils and straight lengths and color-coded red, blue and white. Copper comes in rigid sticks. A single run of pex can snake around a corner, while copper wants a soldered or pressed elbow at every turn. Sunlight is another divider: copper shrugs it off, but pex should not sit exposed for long.
On a real job that matters a great deal. A house with finished walls is often faster to repipe in pex, because flexible tubing can be fished through framing with fewer holes cut in drywall. Copper fits exposed runs, garages and spots where a visible rigid line is fine. Neither is best everywhere, so a good quote says which material goes where.
How do the prices compare?
Redoing every pipe in a house typically runs $1,500 to $15,000 per Bob Vila, whose national average is $7,500. One Los Angeles contractor page gives $4,000 to $15,000, and $7,000 to $10,000 for a mid-sized pex job. Use those as guides only; the price is whatever your written quote says.
We found no verified per-foot price for pex or copper in this area, so none is printed. The gap has a few sources. Copper pipe and fittings cost more as metal. Pex tubing is cheaper but still needs rings, manifolds and tools. Labor hours, wall openings and the patching afterward frequently outweigh both. Ask for quotes that itemize materials, labor, drywall repair and permit fees so that two bids line up fairly.
Is half-inch pex as good as half-inch copper for flow?
Not exactly, because the stamped size is not the true opening. A lot of pex fittings are pushed into the tube and squeeze the passage a little, but copper fittings slip over the outside. Equal on paper, pex may therefore deliver slightly less water, which is why plumbers sometimes choose the next size up or build a manifold feeding each fixture separately.
Long runs and demanding fixtures, such as a rain showerhead or a large tub filler, feel it most. Ask how pipe sizes will be chosen for your actual fixtures, not just whether the reply is half-inch or three-quarter. If poor flow started this search, read what makes water pressure low before spending, since a stuck valve is occasionally the true cause.
How long will each one last?
Manufacturers and trade groups claim long lives for both, but we have no verified local figure, so we print no year count. What counts in practice is the water, the quality of the installation and the pipe's surroundings, more than the tube's label.
Ask about water chemistry. Hardness varies by supplier: San Bernardino Municipal Water reported an average of 242.67 mg/L in 2024, East Valley Water District 152 ppm in 2025, the City of Redlands 148 mg/L for groundwater and 117 mg/L for surface water, and Yucaipa Valley Water District 133.3 ppm. Read your bill to see who serves your address before applying any of those. Fixtures and heaters collect scale no matter which pipe feeds them, and the plumber on site can say if it should affect your choice.
What happens to each in a freeze?
Pex usually fares better when water inside it freezes, because the tubing gives a little, whereas rigid copper can split. That is a general property of the materials, not a local measurement. Neither is freeze-proof, and pipe in an unheated attic, crawl space or exterior wall should be insulated.
On the valley floor in San Bernardino and Redlands, hard freezes tend to be less frequent, so cold tolerance seldom decides the matter. It weighs more in higher, cooler places such as parts of Yucaipa and Oak Glen, or at a cabin or outbuilding. If a pipe has frozen before, say so, because the route may need to change along with the material.
Is the pipe in my older house due for replacement?
Mid-century houses often have galvanized steel, and later ones early copper. Rusty water, dropping pressure, pinhole leaks that return and green stains at joints are the usual signs a line is finished. Steel is covered in galvanized pipe replacement, and leaks under a slab are weighed in repair or repipe.
By Census figures the median home in ZIP 92404 (Del Rosa's ZIP code) dates to 1963, which makes older piping common in that area. Newer tracts in Highland and Yucaipa lean toward later copper or pex. Nothing is certain from the zip code alone, so the plumber should open an access point and look. For whole-job pricing, see the repipe cost page.
Who is legally allowed to do a repipe?
Treat a repipe as permit work. Single-family water re-pipe applications can be filed online with the City of San Bernardino's Building and Safety Division. Under state law, a contractor license is needed when a job requires a permit or exceeds $1,000 in labor and materials. Redlands, Highland and Yucaipa run their own building offices, and unincorporated land answers to the county.
Paperwork, inspection and material choice therefore sit with the contractor, and this is not a weekend project. Use the quote page and a local plumbing business will visit, then write up the material, the scope and the permit. The home page lists our other jobs.
Common questions
Is pex okay for drinking water?
Plumbing-grade pex is made as drinking-water tubing. Have the plumber confirm the markings printed on the tube and that your city's building division accepts it, since we have not checked every city's code adoption. Joints are the usual weak spot, so workmanship counts as much as the tubing.
Can the two materials be combined in one home?
Yes. Transition fittings link them, and many repairs mix the two, such as pex running to an existing copper stub. The plumber should use the proper fittings and keep dissimilar metals from touching directly. Mixed systems are common and perform well when the joints are made correctly.
Will new pex make my water taste like plastic?
A few households detect a faint plastic flavor at the start, which generally fades after the lines are flushed. Copper has no such effect. After the job, run each tap for several minutes, and report any taste that lingers so the lines can be checked.
Do my insurance terms depend on the pipe?
That is a matter between you and your insurer. Some insurers ask about old galvanized or other pipe types, so check with your agent before a repipe and hold on to the permit and invoice. Keep the permit paperwork either way.
What suits a mobile home best?
Many mobile homes use flexible tubing because it routes easily beneath the floor, but we have no verified rule covering every unit. Mention the brand and age of the home when you ask, and let the written quote name the material that fits its layout.
References
- Bob Vila, cost to repipe a house, checked 2026-11-17
- Repiping.com, slab leak repair vs repipe (Los Angeles contractor page), checked 2026-11-17
- San Bernardino Municipal Water Department, 2024 water quality report
- East Valley Water District, 2025 water quality report
- City of Redlands, 2026 water quality report
- Yucaipa Valley Water District, 2025 water quality report
- City of San Bernardino Building and Safety Division
- California Contractors State License Board