Two national guides disagree on what a gas line costs. Bob Vila prints $120 to $1,350 and an average of $558 nationally (checked 2026-11-17). Fixr prints $500 to $2,000 with an average of $800. Because the sources conflict, each stays separate here and nothing is merged.
The written quote, not these guides, fixes your price. To see what the job itself involves, read our gas line page.
What figures are published for a gas line job?
Everything here is national, because we found no San Bernardino figure in the material we read. Bob Vila uses $15 to $25 for each linear foot of fireplace line, and about $20 a foot where the load is a stove, dryer or water heater. A repair is listed by This Old House at $250 to $750 (gas line repair).
| Source | Job | Range |
|---|---|---|
| Bob Vila | Gas line installation | $120 to $1,350, average $558 |
| Fixr | Gas line installation | $500 to $2,000, average $800 |
| This Old House | Gas line repair | $250 to $750 |
Pipe is just one entry. Labor, fittings, permit fees, pressure testing and any cutting into walls or floors appear as well, which is why a short branch to a dryer can cost a fraction of a long run through the house.
Why does one gas line job cost more than another?
Length matters most, since per-foot rates pile up fast. Next are the route (open attic, finished walls, a trench through the yard), how many appliances draw from the line, the pipe material, any upsizing of the meter or main, and the permit.
Other items that move the total:
- Cutting into drywall, concrete or landscaping, and patching afterward.
- The pipe and fittings chosen; local code and the plumber decide what is allowed.
- Flexible appliance connectors, the bendable fitting between rigid pipe and the appliance, usually a small line.
- A new shutoff valve at the appliance.
- A leak test at the end, which belongs in the job.
Does fixing a gas line cost differently than running a new one?
Yes. Repairs usually bill as a trip charge along with parts and labor, and This Old House's $250 to $750 describes an ordinary fix, not a fresh run of pipe. A leak caught early at a fitting is cheaper than cutting out a corroded section, which becomes gas line replacement.
Never patch gas pipe on your own. Gas work is regulated; any job needing a permit calls for a California contractor license. Swapping out a damaged section is covered by the same rule.
Gas odor overrides everything else. Move everybody outside, then ring SoCalGas at 1-800-427-2200, or 911 if anyone is injured or threatened. Do not flick switches or use a phone indoors.
What hourly rate does a gas plumber charge?
We found no verified rate for gas work in particular. Looking at plumbers as a whole, This Old House shows $25 to $200 an hour, and Bob Vila shows $45 to $200. Terms such as "gas safe" belong to other countries; in California the credential that matters is the contractor license, searchable at cslb.ca.gov.
Flat pricing is common on small jobs. Ask for the hourly rate, ask about any minimum, and find out if a flat figure includes the permit and pressure test. What plumbers charge per hour goes deeper on rates.
Where does an earthquake shutoff valve fit into the cost?
No verified price for installing a seismic or earthquake shutoff valve turned up, so we show none. During strong shaking the valve closes the gas on its own. The page on the earthquake shut-off valve describes how it works and when to request one.
It ties into the gas piping, so a contractor holding a California license should fit it, and that contractor can tell you whether a permit applies.
Which pipe and connectors go into a natural gas line?
Local code, the route and the appliance decide, which makes it a question for the plumber and the building department rather than a price table. Rigid pipe normally runs through the house, with a flexible connector on the final stretch to the appliance. We verified no per-foot prices by material, so none appear.
You can control the paperwork. Have the quote name the pipe type, the connector type, the shutoff valve and the test. Ask whether old fittings from an earlier appliance are being reused and why. Reused parts can trim the price, but they bring the age of the old installation with them.
How do I compare gas line quotes without being misled?
Hand every plumber the same scope: same appliances, route and pipe. See that each quote itemizes labor, materials, permit, pressure test and wall repair, because a low total missing the permit is not really cheaper. Set the quotes side by side, go line by line, and question any item that appears on only one.
Then confirm the license with the CSLB, ask who files the permit, and get the price in writing before work begins. The permit office depends on your address: a city Building and Safety Division, or County Land Use Services in unincorporated spots like Muscoy.
Send the details of your job through the quote page. Considering other gas work? The gas plumber page explains what that contractor does.
Common questions
What is the timeline?
Run length, the number of appliances and any wall opening set the pace. A single appliance on a short run is lighter work than redoing the gas side of a whole house. Nobody can promise a time on the plumber's behalf, so ask for a window in writing before you agree.
What do I ask before scheduling gas work?
Collect the contractor license number and look it up. After that, ask who obtains the permit, how pressure testing is done, what pipe material is planned and who restores the wall or floor. Insist the price be written, exclusions included.
Must I stay home throughout?
Have an adult open the door at the start, and the gas will be shut off at the appliance or meter during the work. Whether you must stay the whole time is up to the plumber, so ask when you book. Pilot lights should be relit by the plumber, not by you.
Prices are one part of the job: Smudge Pot Plumbing plumber covers the rest.
References
- Bob Vila, gas line installation cost, checked 2026-11-17
- Fixr, gas line installation cost, checked 2026-11-17
- This Old House, plumber cost guide (gas line repair), checked 2026-11-17
- SoCalGas, cities served list
- San Bernardino County Land Use Services, plumbing permits
- City of San Bernardino Building and Safety Division
- California Contractors State License Board