Skip to the page
Call us (909) 768-7747

Prices ยท San Bernardino

What repiping a house costs in San Bernardino and Redlands

Sources quote $1,500-$15,000 for replacing every pipe in a house. This page covers what pushes a home toward the low or high end, and how to compare bids evenly.

Request a quote

Cross-sections of copper, PEX and galvanized pipe, with galvanized narrowing inside from corrosion.

Bob Vila lists $1,500-$15,000 to replace a home's supply piping, against a national average of $7,500. What you owe appears in the written quote, shaped by fixture count, access and pipe material. This page explains why the span is so wide and what it means for older houses around San Bernardino and Redlands. The work itself is explained in repiping and pipe replacement.

Is a 2,000 square foot house costly to repipe?

No source we opened prices repipes by the square foot, and inventing a rate would be wrong. Bob Vila's range for a typical house is $1,500-$15,000. A Los Angeles contractor page gives $4,000-$15,000 for a full repipe, with mid-sized homes mostly at $7,000-$10,000 in PEX. A home of 2,000 sq ft could plausibly sit mid-range.

Square footage is a weak predictor anyway. Two houses the same size can differ by thousands: one with two baths close to the meter, the other with three baths, a laundry on the far side and a kitchen upstairs. Fixture count, total pipe length and how much wall gets opened do the real work.

Get every bidder to name the fixtures included. A quote that counts hose bibs cannot fairly be set beside one that ignores them.

What about a smaller house, around 1,200 square feet?

A small house has less pipe and fewer fixtures, which tends to favor the low end of the published range. Still, no source we read gives a size-based figure, so we offer none. The one sourced span is Bob Vila's $1,500-$15,000, and the figure you can trust is printed on your written quote.

Small is not a promise of cheap. A 1950s bungalow may have plaster walls, a lone bathroom buried in the core of the house and galvanized pipe that resists every cut. Two plumbers can bid far apart on it, because one intends to open walls and the other to run new pipe through the attic and crawl space.

Redlands has many older cottages. Census Reporter counts 1,372 homes built before 1940 in ZIP 92373 and 1,057 in ZIP 92374, and plaster and lath in houses like those tend to raise patching costs.

Where do the published numbers sit side by side?

We opened the page behind every figure below on November 17, 2026. All are national or Los Angeles numbers, because nothing specific to San Bernardino or Redlands turned up. Treat them as a yardstick, and have each plumber break the total into pipe, labor, permit and wall repair.

WhatRangeSource
Whole-house repipe, typical$1,500-$15,000Bob Vila
National average$7,500Bob Vila
Full repipe, Los Angeles contractor page$4,000-$15,000Repiping.com
Mid-sized home, full PEX repipe, Los Angeles$7,000-$10,000Repiping.com
Pre-repipe plumbing inspection$250-$1,200Bob Vila

The quote you hold sets the price. These rows show where published sources land, not what a San Bernardino plumber will bill.

What drives a quote upward?

Access and material push hardest. Running pipe through an open attic in a one-story house costs less than snaking it past finished ceilings upstairs. Copper is dearer than PEX, and patching plaster costs more than patching drywall. More bathrooms, a second kitchen, or a laundry far from the heater all add pipe and labor hours.

Section of a house comparing an easy attic pipe run with a drop through finished ceiling that needs patching.

Four questions to ask when bids arrive:

  • Material: PEX is generally the cheaper choice and copper the pricier one; PEX versus copper weighs the tradeoffs.
  • Wall repair: does the figure include drywall patching and paint, or the plumbing only?
  • Permit: who applies, and does the price cover the fee?
  • Downtime: how many hours or days without water, and what stands in for it?

Earlier owners' repairs also count. Patches, mixed metals and corroded fittings can add hours nobody planned.

Which local homes tend to need a repipe?

Age starts the clock. In ZIP 92404, around Del Rosa, Census Reporter gives a median build year of 1963 and counts 5,936 homes from the 1950s. In that era builders often used galvanized steel or early copper, and each wears out from inside the pipe. Rust narrows galvanized lines until pressure drops, and thin early copper can develop pinholes.

Hard water hurries it. The 2024 report from the San Bernardino Municipal Water Department gives average hardness as 242.67 mg/L, near 14.2 grains per gallon. Redlands groundwater reads 148 mg/L, East Valley Water District 152 ppm and Yucaipa Valley Water District 133.3 ppm, all gentler.

Newer tracts in Highland, Yucaipa and Verdemont are less likely candidates, though any line can fail; ZIP 92407 shows a median build year of 1987. The galvanized pipe replacement guide lists signs that old steel is failing.

Is a repipe a permitted job?

Plan on it, and check with your building office. The City of San Bernardino lists single-family water re-pipes among permits accepted online, through Building and Safety at 909-998-2000. Redlands has a One Stop Permit Center at 909-798-7536. In Muscoy and Mentone the office is the county's Land Use Services.

Permitted work, and any job of $1,000 or more, requires a contractor license; the CSLB site offers a lookup. Contracts have to be written starting at $500. The CSLB generally caps deposits at 10 percent or $1,000, whichever is less. Confirm all this with the CSLB before signing.

Also find out who handles a failed inspection, and get that answer on paper.

Does a repipe save money in the long run?

Sometimes. A repipe can end the round of leak calls and restore pressure, and it takes away the risk of a wall or slab leak flooding the house. Bob Vila says an inspection at $250-$1,200 can save thousands by showing whether a full repipe or a targeted fix is needed. Paying for leak repair after leak repair can end up costing more.

Decide whether you face a single failure or a pattern. One pinhole in healthy pipe is a spot-repair job. Three leaks in two years along the same pipe suggest replacement. Slab leak repair or a repipe lays that choice out.

An insurer may have a view on old plumbing, so ask your agent what the policy says. To get bids for your house, send the quote form. The home page lists our other services.

Book a plumber quote

Fill this in and we'll arrange a local plumber specialist to come and price the job.

Needed so the business can price the job properly.

We earn a referral fee from the plumber who takes on your job. You pay us nothing.

Common questions

What is the water shutoff schedule like?

It depends on the house, and we promise no schedule. After seeing the layout and access, the plumber can estimate. Water goes off for part of each working day, and wall patching follows. Get a start date, a finish date and a plan for water in between.

What belongs on the quote?

Material for the pipe, fixture count, drywall repair and paint, permit responsibility and payment dates all belong there. Take the plumber's license number and run a CSLB lookup on it. Everything should sit in one document, not in a figure spoken on the phone.

Can we stay put during the repipe?

Yes, but expect dry taps for some hours each day, along with dust and noise from wall work. Many households spend a night or two elsewhere or use a neighbor's bathroom. Ask how water is restored each evening, and whether pets and valuables should be moved.

Can I repipe only one section?

Yes, and many people do just one bathroom or a single leaking branch. Cost tracks how much pipe and wall are involved, and no per-bathroom price appeared in our sources. Have the plumber quote a partial and a full job, since opening a second wall later costs more than finishing in one visit.

References